The necks are neck and neck… and neck?

Jeez, did I just type that?  And will I leave it in?  If so, pardon me,  I’m tired and delirious.

Necks.  Yes.  Almost there.

Bullet point list to reduce potential risk for bad puns:

– laminated 3 strips of mahogany for each neck board.  Did that sometime earlier.  Maybe when tops were drying?

Neck boards

– Laid out the board for scale length, etc… not exciting, picture a board with lines drawn on it.*

– Made a very fancy and elaborate jig for the band saw to cut a 14 degree scarf joint.  I did the last ones with hand tools.

Fancy jig

– Once cut, the cut pieces are placed on top of one another and trued up or flattened (being square is given in all these steps).  Cut was smooth, so sandpaper worked pretty quickly to level everything.  Hand plane is another way to go.

Flattening

– Short piece of the scarf joint is flipped over and put under the longer side, thus making an angled peg head.  Clamped and glued ON the bench.  Use wax paper underneath to avoid gluing TO the bench.**  Stops on the bench placed to keep the joint from sliding out of place.

Scarf gluing

– Excess length on the long end of the neck is cut down into shorter sections and stacked to make the heel.  This is then glued into place at the proper spot.*  Lots of things clamped down to keep things from sliding.  Glue is surprisingly slippery.

Heel stack

– Neck blanks are ready to be cut to the proper angle to the body and dovetailed in.  I’m not so ready.  Need a fresh start for that.  Also need to make dovetail templates.

Neck blanks

* There is obviously a lot of detail skipped here.  If you want to know how this works… don’t ask me.  Read a book, research online, see how the pros do it, that’s what I do.

** I say this not because I actually glued something to my bench.  Notice that I use clamp cauls in these glue ups.  I usually have one side covered in clear tape to keep glue from sticking to it.  I did have one of these flipped today.  One stuck to the face of the one of the headstocks.  Luckily there was little squeeze out and it knocked right off.  I’m just cautioning…Don’t glue anything down to your bench!

Ok, stop typing and go to bed…

Advertisements

Heel cap

Image

Fashioned a heel cap from scrap pieces from my rosette. Glued that in place last night. Started carving the neck early this morning.
Router is in and bits should arrive today so hopefully I can get back to the binding on number two.